| Code: | AC015 |
|---|
| Input | 9V |
|---|---|
| Output | 5V 2100mA x 2 USB and 1xDC 9V 2000mA |
| Battery charge time | 5 hours |
| Battery duration | 40hours about (depends on use and on device connected) |
| Charge status indication | By 4 LEDs |
| Capacity | 10000mAh/37Wh |
| Dimensions | 304g |
Portable battery pack
Portable Li-Ion rechargeable battery pack. Can connect and power balances LW, LG, LGW and KL series.
- Technical Features
Contact Us
Technical Features
Contact Us
DPP-250 printer is a small footprint portable printer that can be used with BEL laboratory balances. Weight values are printed quickly and sharply.
The internal rechargeable battery grants mobility.
Printer DPP-250 is supplied with connection cable to be connected directly to BEL balances.
Small, fast-response thermometer for verify and calibrate the heating source of BEL moisture Analyzers i-Thermo & M5-Thermo series. A calibrated moisture analyzer’s heater allows to have always accurate results. Essential for application where are required certified results.
TX-110 is a high-speed dot-matrix printer suitable for long-term data retention. It is compliant with ISO/GLP procedures, it is equipped with a bright OLED display and has various operating modes:
• DIRECT. Prints out current weight value
• TARE/NET/GROSS. Prints out these values separately
• SUM. Prints out the total value of samples
• AVERAGE. Prints out the average of samples
• FORMULATION. Print out each sample’s weight independently when mixing samples
• PIPETTE CALIBRATION. Calibrate capacity of pipette
• USER DEFINED. Operator can set a multiplicative coefficient
• COMPARATOR. Prints out weight value only when inside a defined range
• AUTOMATIC TIMING. Prints out weight value at defined time intervals
The rear panel ioniser is an accessory that can be easily assembled on the rear of the wind-shield of the already owned BEL Engineering balance.
Using a ioniser is strongly recommended especially with balance with resolution of 0,01 mg or everywhere is required the assurance that the sample is free of static charges to get accurate measurements.
Static charges accumulate in many kind of samples that are being weighed during the laboratory routine. By blowing ions the static electricity is neutralized on charged samples like plastic parts, containers or films. Within seconds the sample is ready to be weighted free from static charges giving the operator accurate results.
Can be used for balances with 3 glass window-shield, resolution 0,01 mg 0,1 mg 1 mg
Density KIT for density calculation of SOLIDS and LIQUIDS for balances with resolution 0,0001gr/0,001gr/0,01gr.
It contains:
• 2 Glass graduated Beaker
• Analogic thermometer
• Glass Plummet
• Basket for floating and not floating samples
• Suspension arm for basket or plummet
• Support for plummet/basket
• Support base for beaker
